Blow mould problem

Blow mould exporter and maker consider the blow mould is one of the easiest mould in medical mould. But what problem should be pay attention when producing blow mould?

There are three questions should be pay attention to the problem as bellow when set the temperature of blow mould:

Firstly,the function of product is good and the stability of dimension is well.
Secondly, cycle time should be short.
Thirdly, energy should be saving when production.
Fourth, It cost only a little waste.

If you pay attention to such question as above, you will make a good blow mould.

Link to this article:Blow mould problem

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki,Thanks